Doremi MCSHD - Manual (Page 47)

(04) Chase Mode Specifies how the V1 will chase to time code.
Off Normal mode of operation when the unit is controlled by a
workstation via the 9 pin RS-422 connection.
LTC In this mode the V1 will chase the time code fed through the
TIME CODE INPUT jack. This mode is recommended when no
RS422 9 pin control is present.
Serial TC In this mode the V1 will chase the time code received on the RS-
422 connection. This mode requires a special cable and it is
recommended only if no RS422 9 pin control is present.
Play lock The play-lock is a chase to time code function. When the play-
lock is set the V1 will chase the incoming Time Code to start the
play, but then will keep in playing until the incoming time code
stops completely (i.e. the same value and the time code is not
incrementing), or disappears.
After the playback starts the incoming Time Code is not checked for
validity, it will only be checked for presence or if not moving.
Note: The Chase to LTC Mode above is different than the OPTION PLAY
Command also referred to as Chase Command (see paragraph 6.5).
(05) Vid Source Displays the input source, “SDI” for HD-SDI and SD-SDI.
(06) Aud Source Specifies the audio input format. Select between Analog, AES or SDI (for
embedded audio on SDI). Formats available depend on the options installed.
(07) INFO/T-Left This menu selection provides information on the current V1 settings and the
parameters of the currently loaded file. None of these settings can be changed
in this menu.
V_1.OM.000160.DRM Page 47 of 85 Version 5.2
Doremi Labs