Doremi MCSHD - Manual (Page 50)

10.1 Transport
The Transport settings feature functions that affect the general playback and record operation of the
V1.
Disk Access This option will allow you to write protect your file. Select between Play and PL-
RE (Play & Record (Default)). When Play is selected, you will not be able to
record on the file or initialize the disk.
Frame Mode Select between Frame Mode ON, OFF and Play.
When ON the V1 will stop on a frame and in slow motion it will play frame by
frame.
When OFF the V1 will stop on a field and in slow motion it will play field by field.
In PLAY, the V1 will stop on a field and in slow motion it will play frame by
frame.
This setting also affects the Step Recording option. For Slow Motion
application, the frame mode must be OFF. When the V1 is in stop (freeze)
mode and Frame Mode is set to ON a full video frame will be displayed.
StopMod Select the video output to be displayed after the V1 receives a stop command.
Set stop mode to either show a field/frame from the drive (Still) or show the
image present on its input (EE).
Jog On Ch Select between “1&2”, “3&4”, “5&6” and “7&8”. When the V1 is playing at any
speed below 100%, the audio will output from only two channels. Use this
option to select which tracks the audio will be on when the V1 is playing at any
speed below 100%.
FastMod Select between Norm (normal) and Enhan (enhanced). Enhanced mode will
provide the best video preview in Fast Forward and Fast Rewind
Set to Normal for V1-HD installed with the independent record and play option.
JogSpeed Sets the maximum speed in Jog mode to 100% or FULL (no limit).
PL1Field<% The speed shown in percentage will define the speed under which the V1 will
only play odd fields. If you want to play odd and even fields at all speeds, select
0%. For Slow Motion applications you must set this parameter to “0” and save
it.
ChaseFWL The number of frames defined in this option will set the free-wheel of the chase
mode between 1 and 10 frames or “0”. If your time code is reliable set to “0”.
When set to a value between 1 and 10, the V1 will play the same field for the
specified amount of frame(s) before it stops and wait for the new time code to
chase.
This function is useful to reduce the audio noise during the chase command. If
you know that your source does not have drop-outs in the time code, set this
value to 1.
LimToSeg Limit to Segment; specifies the operation of “Loop Mode” below. When
“LoopMode” is set to ON, the V1 will record (play) in a loop specified by the
V_1.OM.000160.DRM Page 50 of 85 Version 5.2
Doremi Labs