11 controller menu – Doremi MCSHD User Manual
Page 58
11 Controller Menu
The front panel controls of the V1 are called the “RCV2 controller”. The RCV2 controller
communicates with the V1 via RS-422. The controller has several unique functions. To call up the
CONTROLLER MENU hold the ESCAPE button and press the menu up arrow key (or down key ).
Use the arrow keys to scroll through the menu selections. The TOGGLE button changes the
parameters for the selected menu. Press TOGGLE to increase the parameter and hold OPTION
and TOGGLE to decrease the parameter.
To disable the RCV2 and prevent accidental operation, hold the OPTION button then press
ESCAPE. Press again to unlock the RCV2. When the RCV2 is in “disable mode” the letters “DIS”
will be displayed in the top right corner of the 4 lines LCD.
To reset the controller (soft reset) hold the 1, 2, 3 or 4 buttons and press CLEAR. This may be
necessary to reset the optional Video LCD display if you switch between NTSC & PAL formats.
(00) RCV2 Version
Displays the firmware version number for the RCV2 controller.
(01)
Video
Use the TOGGLE button to switch the front panel LCD monitor “on” or
“off”. Default is “on”
(02)
Composite Out
Switches the composite output on the rear panel “on” or “off”. Default
is “on”.
(03)
Burn In Window
When ON, the burn in window will be enabled on the confidence LCD
monitor (it needs to also be enabled in the OPTION MENU setting). -
Default is “on”.
(Always active on LCD monitor and on composite output)
(04)
Delay Mode
Configure for single drive operation (V1-HD with independent
record and play option only)
This is used for broadcast delay to define the time delay between the
recorder and the player(s). Ensure that the V1 is not recording.
Select the player (channel 2) and enter the delay time desired and
press ENTER. The record and play channel will locate to 0 time code,
the recorder will start recording and the player will wait for the time set
for delay to elapse, and will then start playing back automatically.
The transport controls on the player (channel 2) will be disabled when
the time delay function is engaged. To stop the delay function select
the recorder (channel 2) and press STOP.
Default is “off”.
(05)
Preroll
Used in conjunction with Slomo Mode (See below). When a time value
is entered the RCV2 identifies the pre-roll time from the location point.
This helps to compensate for the delay between the action being
recorded and the push of the save button.
V_1.OM.000160.DRM Page 58 of 85
Version 5.2
Doremi Labs