Doremi MCSHD - Manual (Page 49)

Mode 1R/P: Indicates a standard record or play engine
1R-1P (optional): Indicates a simultaneous record and play engine.
To change the mode press the TOGGLE key and the hit ENTER. You will next
need to save your settings, wait 30 seconds and recycle power on the V1.
Netpos None: For all units that are not sharing storage (V1-HD and V1-UHD), it should
be set to None.
To change the mode press the TOGGLE key and the hit ENTER. You will next
need to save your settings; wait 30 seconds and recycle power on the V1.
GNet For V1-UHD and V1-HD with the Gigabit Ethernet Option installed.
All units equipped with the Gigabit option will have 2 Ethernet connectors on the
back panel. The lower connector is the built-in 100BT and the higher connector
is the Gigabit. Only one of the two connectors can be active. The default
setting when the unit is ships is Gigabit Enabled.
To switch to100BaseT select “Disable” press ENTER, save settings MENU (5)
and reboot the unit.
To enable Gigabit Ethernet select “Enable” press ENTER, save settings MENU
(5) and reboot the unit.
For best performance, the PC connected to the V1-UHD using Gigabit should
have the Jumbo Mtu set to 7500. To change the Mtu on your PC’s Gigabit card:
Right click on My Network Places and select Properties
Right click on your Local Area Connection for that card and select
Properties
Click on Configure, Click on Advanced, Click on Jumbo Mtu and select
7500 and hit OK to save all changes.
V_1.OM.000160.DRM Page 49 of 85 Version 5.2
Doremi Labs