Doremi MCSHD - Manual (Page 38)

Operation:
All menus are pre-configured at the factory. Just make sure that LOOP MODE is set to ON on the
Recorder and on the Player:
1. Press the 1 button to select the Recorder.
2. Go to Menu 7 and make sure that the available recording time exceeds the duration of the
delay. If not hit OPTION CLEAR and erase previous CLIPs one by one until the remaining
time in Menu 7 exceeds the duration of the delay.
3. Go to OPTION MENU (3) and set the Dur: to a value that exceeds your delay by 30 seconds
and hit ENTER, then hit ESCAPE.
4. Hold the OPTION key and hit SAVE, then hit ENTER to accept the CLIP name assigned by
RCV2.
5. Press the 2 button to select Player 1
6. Hold the OPTION key and hit RECALL, then turn the JOG WHEEL until you see the CLIP
you just created in step 4, then hit ENTER to load the CLIP on Player 1.
7. Hold the ESCAPE Button and press the Up Arrow key
8. Keep pressing the Up Arrow Key until you see Delay
9. Press the TOGGLE button and enter 01:00:00:00 (or any other delay) using the numeric
keypad then press the ENTER button. This will locate both recorder and player to 0 time
code. The recorder will start recording and the player will wait for an hour (or any value set in
delay), then it will start playing.
10. Press the ESCAPE button
To end the time delay operation, select the record channel (channel 1), go to the CONTROLLER
MENU (04) Delay Mode and press the TOGGLE button.
To stop the playback but keep the V1 recording, select the playback channel, go to the
CONTROLLER MENU (04) Delay Mode and press the TOGGLE button.
7.5 Slow Motion Replay: V1-HD Only
This paragraph describes how to set the V1-HD for slow motion replay applications. This is only
available on early model V1-HD with the independent record and play option.
Ensure that Channel-1 is in 1R-1P mode by checking OPTION MENU (00).
The 1, 2, 3, 4 buttons on the front panel of the unit will allow access to the channels:
 Button 1 will select the Recorder
 Button 2 will select the Player
 Buttons 3 and 4 have no effect
Setup:
1. Go to the OPTION MENU (1) Transport and set FrameMod to “off”.
2. Go to the OPTION MENU (1) Transport and set PL1Field<% to “0”.
3. Go to the OPTION MENU (5) Save Setngs to save the settings above.
V_1.OM.000160.DRM Page 38 of 85 Version 5.2
Doremi Labs