Doremi MCSHD - Manual (Page 27)

 During formatting, the message Formatting... is shown. During initialize, the message
Initializing is shown. During drive copy, the message Copying... is shown, once done,
Copy Complete is shown and if source drive has invalid recording, Bad Param or Copy
aborted is shown.
 During the drives mounting (insert) and un-mounting (eject), the message No disk is
displayed.
The Third and Fourth lines of the LCD display the Audio Level meters.
5.2.5 SCSI Drives
The V1 is shipped with either hard-mounted drive(s), a removable drive using a Data-Express or
with external raid5 storage.
When mounted in a removable tray, hard drives can be removed (or installed) while the V1 is on-line
(without the need to shut the unit off).
To remove (or install) a drive, insert the supplied drive key into the key slot on the receiver below the
lit SCSI ID number and turn it clockwise (or counter-clockwise). When removing a drive, turning the
key clockwise will unlock the drive and cut power off from it causing it to spin down.
Before removing a drive, wait until it has completely finished spinning down. This will usually
take about 30 to 40 seconds depending on the drive.
5.2.6 LCD Video Display
Figure 21: LCD Video Display
Optional LCD video confidence monitor. The display can be turned OFF or ON in the
CONTROLLER MENU (01) Video option.
To reset the entire front panel controller (soft reset) hold the 1, 2, 3 or 4 buttons and press
CLEAR. This may be necessary to reset the LCD video monitor if you switch between
NTSC frame-rates & PAL frame-rates formats.
V_1.OM.000160.DRM Page 27 of 85 Version 5.2
Doremi Labs