Doremi MCSHD - Manual (Page 15)

3.2 Power On and Shut Down
To power the V1 on or to shut it down, just press on the power button located on the front panel –
make sure the V1 is connected to power according to paragraph 3.1.3.
Figure 6: Power Button - Front Panel
3.3 Ethernet
To set up the Ethernet network, connect the Ethernet cable to the Ethernet port of the V1 unit as
presented below – note that if your unit is fitted with an optional Gigabit Ethernet connector, that
optional connector has to be used instead of the connector presented below:
Figure 7: Ethernet Connector – Rear Panel
V_1.OM.000160.DRM Page 15 of 85 Version 5.2
Doremi Labs
Power Button
Default Ethernet
connector