Altera Cyclone V SoC Development Board - Manual (Page 12)

2–4 Chapter 2: Board Components
Board Overview
Cyclone V SoC Development Board November 2013 Altera Corporation
Reference Manual
U6 Flash memory
512-Mb synchronous flash devices with a 16-bit data bus for
non-volatile memory.
U28 I 2 C EEPROM 32-Mb I 2 C serial EEPROM.
Communication Ports
J25 PCI Express socket PCI Express Gen1 ×4 socket.
J12 HSMC port
Provides four transceiver channels and 84 CMOS or 17 LVDS channels
per the HSMC specification.
J2 Gigabit Ethernet port
RJ-45 connector which provides a 10/100/1000 Ethernet connection
via a Micrel KSZ9021RN PHY and the FPGA-based Altera Triple Speed
Ethernet MegaCore function in RGMII mode.
J33, J34 Gigabit Ethernet port
RJ-45 connectors which provides a dual 10/100 Ethernet connection
via a Renesas uPD60620A PHY in MII mode.
J35 CAN port DSUB 9-pin connector for CAN networking.
J8 USB-UART port USB connector with USB-to-UART bridge for RS-232 terminal.
J1 USB OTG port Micro-USB connector for OTG interface.
J3 Micro SD card socket Micro SD card interface with 4-bit data line.
J15, J16 Debug headers Two 2×8 headers for debug purposes.
Video and Display Ports
J15 Character LCD
Connector that interfaces to a provided 16 character × 2 line LCD
module along with two standoffs.
J14, J17 SDI video port
Two 75- Ω system management bus (SMB) connectors which provide a
full-duplex SDI interface through a LMH0303 driver and LMH0384
cable equalizer.
Power Supply
J22 DC input jack
Accepts 16-V DC power supply. Do not use this input jack while the
board is plugged into a PCI Express slot.
SW5 Power switch
Switch to power on or off the board when power is supplied from the
DC input jack.
Table 2–1. Board Components (Part 3 of 3)
Board Reference Type Description