LINK Systems 5100-8 Tonnage & Analog Signal Monitor User Manual
Installation and operating manual
Table of contents
Document Outline
- INTRODUCTION
- 2 DEFINITIONS AND TERMINOLOGY
- 3 OPERATION
- 3.1 Main Operator Terminal Screen
- 3.2 The Tonnage Monitor Main Screen
- 3.3 The Tonnage Monitor Diagnostic Screen
- 3.4 The Tonnage Monitor Bypass Setup Screen
- 3.5 The Tonnage Monitor Graph Screen
- 3.6 The Tonnage Monitor Graph Settings Screen
- 4 CONFIGURATION
- 4.1 Turning the Tonnage Monitor ON in Device Config
- 4.2 Setting the Number of Channels
- 4.3 The Tonnage Monitor Configuration Screen
- 4.4 The Tonnage Monitor Machine Settings Screen
- 4.4.1 Units
- 4.4.2 Machine Rating
- 4.4.3 Machine Rating Alarm Level
- 4.4.4 Max Forward Setpoint Level
- 4.4.5 Max Reverse Setpoint Level
- 4.4.6 Number of Data Windows
- 4.4.7 Filter Frequency
- 4.4.8 Sample Window Start Angle
- 4.4.9 Sample Window End Angle
- 4.4.10 Auto-Zero Start Angle
- 4.4.11 Auto-Zero End Angle
- 4.4.12 Peak High Limit Stop Type
- 4.4.13 DW High Limit Stop Type
- 4.4.14 Auto Unbypass Leaving Setup Mode
- 4.4.15 Bypass Low Limits in Setup Mode
- 4.4.16 Resetting Alarm Counters
- 4.5 The Tonnage Monitor Calibration Screen
- 4.6 The Machine Rating De-rate Table Screen
- 5 JOB SETUPS
- 6 INSTALLATION
- 7 CALIBRATION
- 8 OPTIONAL COMPONENTS
- 9 TROUBLESHOOTING
- 10 PART TRACKING
- 11 PARAMETER ENTRY AND ACCESS CONTROL