2 the tonnage monitor main screen, The tonnage monitor main screen, 3 operation 3.1 main operator terminal screen – LINK Systems 5100-8 Tonnage & Analog Signal Monitor User Manual
Page 15: Figure 4: operator terminal main screen
Doc
#:
L-802-1110 Page
13 Rev.
02
3 OPERATION
3.1 Main Operator Terminal Screen
The operator terminal main screen shown in Figure 4 provides the current status of the tonnage monitor
module directly beside the TONNAGE MONITOR softkey and indicates if attention is required by the
module.
Stroke
Mode
Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
Current Status
Counter OFF
MAIN
SCREEN
PRESS
CONTROL
AUTO
SETS
TONNAGE
MONITOR
DIE
PROTECTION
LIMIT
SWITCH
JOB
SETUPS
0
0
SPEED
ADJUST
Status:
Status:
All Conditions OK
Job Num. Description
Counter Limit Quantity
ORDER
BATCH
SPM
60
%Load
90
Off
Off
Program/Run Switch
TOP
COUNTERS
10012
Left Support Bracket
ANALOG
MONITOR
Program/Run Switch
Status:
All Conditions OK
Status:
All Conditions OK
Status:
All Conditions OK
Status:
All Conditions OK
Stroke
Mode
Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
Current Status
Counter OFF
MAIN
SCREEN
PRESS
CONTROL
AUTO
SETS
TONNAGE
MONITOR
DIE
PROTECTION
LIMIT
SWITCH
JOB
SETUPS
0
0
SPEED
ADJUST
Status:
Status:
All Conditions OK
Job Num. Description
Counter Limit Quantity
ORDER
BATCH
SPM
60
%Load
90
Off
Off
Program/Run Switch
TOP
COUNTERS
10012
Left Support Bracket
ANALOG
MONITOR
Program/Run Switch
Status:
All Conditions OK
Status:
All Conditions OK
Status:
All Conditions OK
Status:
All Conditions OK
Figure 4: Operator Terminal Main Screen
The status of the tonnage monitor module could indicate any of the following conditions:
"All Conditions OK"
No alarms exist and no stop signals are being given by the module.
"Error Condition Exists"
An alarm or an error has been detected and must be reset before the
control will allow stroking.
"System Bypassed”
The module is bypassed and will not supply a stop signal to the control if
an alarm occurs.
"Option is NOT Installed" The control has not been configured to recognize the module.
"Communication Failure" A problem exists in the communication link between the operator terminal
and the module (see section 9.1 on page 74 for details).