Kipp&Zonen Brewer MkIII - Manual (Page 86)

MKIII OPERATOR’S MANUAL 83
DCFJJJ.nnn - Dispersion constants
The Dispersion Constants are used to calculate the ozone
wavelength of the exit slits.
# Example Name
1 Disp Header
2 2856.96 intercept for slit 1
3 7.674577E-02 slope for slit 1
4 -7.251786E-07 quadratic for slit 1
5 2896.561 intercept for slit 2
6 7.600413E-02 slope for slit 2
7 -7.387072E-07 quadratic for slit 2
8 2933.527 intercept for slit 3
9 .0751006 slope for slit 3
10 -7.337653E-07 quadratic for slit 3
11 2968.578 intercept for slit 4
12 7.440717E-02 slope for slit 4
13 -7.512483E-07 quadratic for slit 4
14 3003.31 intercept for slit 5
15 7.325987E-02 slope for slit 5
16 -7.065609E-07 quadratic for slit 5
17 2823.907 intercept for mercury exit slit
18 .0774763 slope for mercury exit slit
19 -7.259538E-07 quadratic for mercury exit slit
20-36 - Not used
UMKSETUP.nnn - Umkehr setup file
# Example
1 SXUNI4M.DAT
2 STDTABS.DAT
3 O3TABLE.DAT
4 CQMS.DAT
5 4.1099 2.3155 1.5600 0.8637
6 0.6760 0.3187 0.1490 0.0776 .. ozone coefficients for #039 STN TMO
7 3 6 11 12 1 1.0 812.0
8 999 1 34.838 0
9 0 ... debug file
1 - 4. Tables used in the calculation of Umkehrs.
5 - 6. Ozone coefficients
7. This line has 7 parameters:
1 Minimum starting zenith angle
2 Maximum starting zenith angle
3 Minimum ending zenith angle
4 Maximum ending zenith angle
5 Output control flag
6 Ozone scaling factor (used with Dobson data)
7 Surface pressure of the station (in mmHg)
8. This line has 4 parameters:
1 Station identifying number (3 digits)
2 Parameter no longer used (set to 1)
3 Latitude of station - used for first guess
4 Output control flag (set to 0)
9. Flag for debugging purposes only.
APPENDIX B CONFIGURATION FILES