Kipp&Zonen Brewer MkIII - Manual (Page 31)

MKIII OPERATOR'S MANUAL 28
final tightening. Care must be taken not to overtighten the bolts as the rubber feet may be
damaged.
4. Connect the AC Power Cable to the 120V/230V connector on the underside of the Tracker,
and connect the Data Communications Cable to the Surge Suppressor Box assembly
mounted to the underside of the Tracker.
Always connect the power cables first, before connecting the communication cables.
5. Connect the remaining cables from the Tracker to appropriate connectors on the Brewer –
Note that each cable / connector combination is unique, which makes it difficult, but not
impossible, to mate the cables incorrectly.
6. Turn ON the Tracker Power Switch and the Brewer Power Switch - both Green Power
indicators will come on, the Brewer will go through an initialization sequence once again, and
the Tracker will be difficult to turn by hand.
7. Turn the Brewer and the Tracker Power Switches OFF, and remove the communications
cable from the Tracker.