Eurocom D270ES VIPER - Manual (Page 126)

Upgrading The Computer
Upgrading the System Memory (RAM) 6 - 7
6
5. Gently pull the two release latches ( & in Figure 6 - 4 ) on the sides
of the memory socket toward the sides of the computer.
6. The module will pop-up, and you can remove it.
7. Repeat the process for the second module if necessary.
8. Insert a new module holding it at about a 30° angle and fit the connectors
firmly into the memory slot.
9. The module will only fit one way as defined by its pin alignment. Make sure
the module is seated as far into the slot as it will go. DO NOT FORCE IT; it
should fit without much pressure.
1 2
1 2
3
Contact Warning
Be careful not to touch
the metal pins on the
module’s connecting
edge. Even the clean-
est hands have oils
which can attract parti-
cles, and degrade the
module’s perfor-
mance.
Figure 6 - 4
Removing/
Installing a RAM
Module (part I)
3