The power-on self test (post), Post screen, Figure 5 - 1 post screen – Eurocom D270ES VIPER User Manual

Page 102: The power-on self test (post) -3, Bios utilities the power-on self test (post) 5 - 3, Figure 5 - 1

BIOS Utilities

The Power-On Self Test (POST) 5 - 3

The Power-On Self Test (POST)

Each time you turn on the computer, the system takes a few seconds to con-
duct a POST, including a quick test of the on-board RAM.

As the POST proceeds, the computer will tell you if there is anything wrong.
If there is a problem which prevents the system from booting, it will display a
system summary and prompt you to run Setup.

If there are no problems, the Setup prompt will disappear and the system will
load the operating system. Once that starts, you can’t get into Setup without
rebooting.

POST Screen

1.BIOS information
2.CPU type
3.Memory status
4.HDD identification

notice

5.Enter Setup prompt

appears only during
POST

Note: The POST
screen as pictured is
for guideline purposes
only. The POST
screen on your compu-
ter may appear slightly
different.

Figure 5 - 1

POST Screen

Phoenix Bios 4.0 Release 6.0

BIOS Revision: 1.00.08

KBC/EC Firmware Revision: 1.00.01

CPU = Intel(R) Pentium(R) 4 Mobile CPU 1.60GHz

636K System RAM Passed

223M Extended RAM Passed

512K Cache SRAM Passed

System BIOS shadowed

Fixed Disk 0: HITACHI_DK23DA-20

ATAPI CD-ROM: DW-224E

Mouse Intialized

Press to enter SETUP