Delta MMC120 - Manual (Page 89)

MMC120 Linear Motion Control Module Appendix A: DCS120
Delta Computer Systems, Inc. 360/254-8688 89
[READBACK]
The [READBACK] parameter determines whether DCS120 starts up in the Readback mode or Write mode. The
following configuration allows you to execute DCS120 and to come up in the readback mode without initializing the
axis:
[FORCEINIT] NO ; DEFAULT
[READBACK] YES ; DEFAULT
This configuration allows DCS120 to initialize all axes and come up in the readback mode:
[FORCEINIT] YES
[READBACK] YES ; DEFAULT
[LOOKONLY]
This keyword controls access to the initialization and command parameters. When [LOOKONLY] is set to YES,
DCS120 can only monitor status and plot graphs. When it is NO all capabilities are enabled.
[BOARD]
This keyword has one parameters: the module name. This name is displayed in the upper right corner of the main and
graph screens. This name is limited to six characters. It can be edited to reflect the function of the module, such as
edger, or qdbnd.
[AXIS]
This keyword has only one parameter: the name of the axis. The axis name can be up to five characters long; longer
names are truncated. The name can be chosen to indicate the function of the axis. There must be two axis keywords
immediately after each board keyword.