Delta MMC120 - Manual (Page 17)

MMC120 Linear Motion Control Module Setup Checklist
Delta Computer Systems, Inc. 360/254-8688 17
SETUP CHECKLIST
Wiring (Pages 18 and 19)
Wire magnetostrictive transducers to 9-pin terminal block on MMC120. See your transducer documentation
for connector pinout or cable color code information.
Wire MMC120 drive outputs (3-pin terminal block) to actuators (+out = axis extends)
Install and connect power supplies needed for your transducers
Installation (Page 18)
Define input and output registers
I/O Map the MMC120 ( DCS MMC 120 0x , 4 input registers, 4 output registers)
Reserve memory for the module (parameters, profiles, event steps)
Start-up and Tuning
Run DCS120 setup program
Configure MMC120 to match transducers (See Configuration Word, bits 1 - 4 on page 25)
Set Extend and Retract Limits
Tune the axes
Save parameters in DCS120 to a .BD1 file (S filename command - page 78)
Save parameters to Flash memory (page 43)
Read parameters and profiles into Programmable Controller