Troubleshooting flow charts – Generac Power Systems 53187 User Manual
Page 129
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PARTS
ENGINE ELECTRICAL SYSTEM
1
SECTION 5.8
TROUBLESHOOTING FLOW CHARTS
Section 5.8
TROUBLESHOOTING FLOW CHARTS
Introduction to Troubleshooting
Use the TROUBLESHOOTING FLOW CHARTS in this section in conjunction w ith the test procedures outlined
in Section 5.9. Test num bers in the FLOW CHARTS correspond w ith the num bered tests in Section 5.9.
It is suggested that you read Section 5.1 carefully. Three different DC control system s are covered by the FLOW
CHARTS, arbitrarily designated as Type 1, Type 2 and Type 3. Section 5.1,
INTRODUCTIO N T O DC CO NTRO L
SYSTEM S,
explains the differences betw een the three types of system s.
Problem 1 A- Engine Will Not Crank (Type 1 DC Control System)
F^PLACE BAD
CIRCUIT BREAKER
REPAIR, RECONNECT OR
REPLACE BAD WIRE(S)
REPAIR OR REPLACE STARTER
AS NECESSARY
PAGE 5.8-1