YSI 9600 - Manual (Page 9)

• After removal from the box, place the 9600 on a flat surface, usually the floor, and inspect it for any
damage that might have occurred in transport. If any parts are damaged or missing, contact your YSI
representative immediately. If you do not know which YSI dealer you obtained your YSI 9600 from,
refer to Section 13 of this manual for contact information.
Lift by Bail
• If no damage is present, proceed with the removal of the carousel from the outer housing of the 9600
as defined in the steps below:
• Using a large Phillips head screwdriver, remove the four (4) screws from the sides of the instrument
assembly which hold the inner carousel to the outer assembly as shown in the picture below. Make
certain to retain the screws in a safe place for reassembly prior to use of the 9600.
Remove these screws
• After the screws have been removed, grasp the bail and lift straight up to remove the carousel as shown
in the picture below. If the carousel binds to the outer shell, have a second person hold the outer shell.
Place the carousel in an upright position on the floor or a bench top after removal.
YSI Environmental 9 Model 9600 Nitrate Monitor