YSI 9600 - Manual (Page 65)

If you would like to view ONLY the nitrate concentration in your graph, the sample absorbance parameter
can easily be removed. Click on the Setup selection in the upper menu bar and then select
Parameters|Add/Remove as shown below.
Highlight the Sample Absorb parameter on the left side of the box and then click the Remove selection.
Note that you are NOT deleting this parameter – only moving it to a location where its data will no longer
show in the graph or the data table. The Sample Absorb parameter can be included in future data displays
simply by highlighting it and then clicking the Add button to move it back to the left (active) side of the
display. After removal of the Sample Absorb parameter, the following display will appear.
If you want to view only a part of the data displayed, use the Limit Data Set icon which is found on
the toolbar above the graph. To view only the first half of the data file, first click on the icon and then
move the cursor to the beginning of the graph. Click once to generate the first “delimiting” x value. Then
move the cursor to the halfway point on the x-axis and click again. The following “delimited” plot and
table will be shown.
YSI Environmental 65 Model 9600 Nitrate Monitor