YSI 9600 - Manual (Page 110)

.
REDRAW
If part of a graph is not displayed it could be because your window is sized too small to display it or
because you have just returned to EcoWatch from some other application. Maximizing the window and
choosing this command should display your graph correctly
Shortcuts
Toolbar:
CANCEL LIMITS
Choose this command to cancel the limits set by the Limit Data Set command.
7.6.7
SETUP
PARAMETER
Lets you select which parameters you want to analyze and how they will appear.
Add/Remove
There are two lists, Selected Parameters and Available Parameters. If, for example, you wish
to graph another parameter, you must highlight it on the Available Parameter list and then click
the Add button to move it over to the Selected Parameters list.
This is also where you decide the order in which the parameters will appear in both the table and
the graphs. If you choose to have two traces per graph, then the first graph will have the first and
second parameters on this list, the second graph will have the third and fourth parameters and so
forth. The parameters will appear in the Selected Parameters list in the order that they were
added. To rearrange the order, highlight the parameter you wish to move and then use the up and
down buttons to move it to the desired spot in the order.
YSI Environmental 110 Model 9600 Nitrate Monitor