TeeJet 854 Sprayer Control - Manual (Page 8)

www.teejet.com
3
854 Sprayer Control
• To enter the OEM Program Mode:
• Begin with the console powered “Off”.
• Press the MINUS key and the PROGRAM
key simultaneously to turn the console “Off”
if required.
• Press and hold the PLUS and MINUS
keys. While still holding them, press the
PROGRAM key 4 times.
• Release all keys.
Figure 3-1: Entering OEM Program Mode
nr 5
SEC
Number.of.Boom.Section.
Switches.On.the.Console
The number of individual boom section switches
actually present on the control console (regardless
of the number of boom sections that are on the
sprayer) can be programmed.
• Use the PLUS or MINUS keys to modify
the value.
• 1 to 11 switches can be programmed.
• This number will determine the number of spray
tips per boom section during the System Setup
Mode.
• Press and hold the AUTO/MAN key for 3
seconds to set the value to “1”.
• Press the AUTO/MAN key once to reset the
value to the default value of “5”.
• Press the PROGRAM key to accept the
value and advance to the next program step.
Lane.Width.(GLM.Working.Units)
When Gallons per Lane Mile “GLM” is selected as
the working units, this screen will allow the operator
to enter the lane width in inches.
• Use the PLUS or MINUS keys to modify
the value.
• Press the Program key to accept the value
and advance to the next program step.
Figure 3-2:
Lane Width (GLM Working Units) Window
144
CHAPTER 2 - OEM PROGRAM MODE
The OEM Program Mode contains configuration steps for the console. The console is typically pre-configured
before being shipped. Changing the configurations is not recommended unless instructed to do so as it may
adversely affect the performance of the controller.