TeeJet 854 Sprayer Control - Manual (Page 39)

www.teejet.com
34
854 Sprayer Control
Number.of.Tips.Per.Boom.
Section
Enter the number of tips on the boom section
corresponding to boom Section 1. The number of
tips entered here is specific to the preset being used
(in the following example, preset 2 is being used).
• Use the PLUS or MINUS keys to adjust
value.
• Press the PROGRAM key to advance to
next step
Once the PROGRAM key has been pressed,
pressing the PROGRAM key again will advance
the console to Section 2. Continue programming
the number of tips for each boom section until all 5
possible boom sections have been programmed. If
a particular boom section switch is not used, set the
value to “0”.
Figure 5-3: Number of Tips
6
-2-
SeC
1
Density
Alternate Density Used
If a product carrier other than water will be used,
change this value to “YES”. Otherwise, leave at
“NO”.
• Use the PLUS or MINUS keys to select
“YES” or “NO”.
• Press the PROGRAM key to advance to the
next step
Figure 5-4: Alternate Density
dEns
Density Value
NOTE: This screen will only be displayed if
Alternate Density Used was set to “YES”.
If a carrier other than water (i.e., liquid fertilizer) is
being used, enter the density value.
• Use the PLUS or MINUS keys to change
the value.
• Press the PROGRAM key to advance to the
next step