TeeJet 854 Sprayer Control - Manual (Page 26)

www.teejet.com
21
854 Sprayer Control
Figure 4-19: Section Valve Type
2
SEC
tYPE
Pressure.Regulating.Mode
The Pressure Regulating Mode instructs the 854
where the regulating valve is plumbed into the
system. Once configured correctly, this value should
not change unless the regulating valve is physically
moved to a new point in the plumbing.
• The default value is “BYP” which indicates that
the pressure regulating valve is plumbed in a
bypass line.
• If the setting is correct, press the PROGRAM
key to accept the value and advance to the
next step.
When programmed in the Bypass Mode, with the
controller in Manual Mode “Man”, the pressure
regulating valve should:
• Close when the PLUS key is pressed.
• Open when the MINUS key is pressed.
Figure 4-20: Pressure Regulating Mode
bYP
re6
If the pressure regulating valve is plumbed in a
supply line to the booms, it is considered in the
“throttling” position.
• Use the PLUS or MINUS keys to adjust
the value to “thr” (throttling mode). The polarity
that the console uses to control the regulating
valve will be reversed.
• Press the PROGRAM key to accept the
value and advance to the next step.
When programmed in the Throttling Mode, with
the controller in Manual Mode “Man”, the pressure
regulating valve should:
• Open when the PLUS key is pressed.
• Close when the MINUS key is pressed
Figure 4-21: Pressure Regulating Mode
THr
re6