TeeJet 854 Sprayer Control - Manual (Page 44)

www.teejet.com
39
854 Sprayer Control
Area/Volume.Display
WARNING! Clearing the area/volume counter
as indicated blow does not save the
information. If the information is to be saved
for future reference, refer to the Memory
Feature of this User Guide.
With the Master Boom Switch in the “On” position,
the 854 Sprayer Control counts application area and
measures the total volume applied.
The area counter measures treated acres and
is dependent on the values programmed for the
number of tips per boom section and the tip spacing.
The volume measure is dependent on flow meter
pulses, if a flow meter is present. If not, it is calculated
based on pressure signals from the Pressure
Transducer.
Depending on console programming during OEM
Setup Mode, the lower right of the console will
display:
• volume sprayed
• area covered
• both (alternating every three seconds)
To clear the area counter/volume measure:
• Set the Master Boom Switch to the “Off”
position.
• Press and hold the AUTO/MAN key for
three seconds.
• The controller will display a message asking if
the field counter should be cleared.
• Use the PLUS or MINUS keys to select
either “YES” or “NO”.
• Press the PROGRAM key to accept the
change and return to normal operating mode.
NOTE: The area/volume measure can only be
cleared from the normal operating mode
with the Master Boom Switch in the “Off”
position.
Figure 7-1: Area/Volume Display
Ac
33
52.25
20.0
0.0
GPA
CLr
CNTR
YES
FLO
CHAPTER 6 - FEATURES