TeeJet 854 Sprayer Control - Manual (Page 18)

www.teejet.com
13
854 Sprayer Control
Selection.of.Working.Units
The 854 is capable of working in units of:
• US (US Gallons Per Acre)
• TRF (Turf) (US Gallons/1000 ft2)
• IMP (Imperial Gallons Per Acre)
• NH3 (Pounds of N per Acre)
• GLM (US Gallons Per Lane Mile)
• SI (Metric Liters Per Hectare)
To establish the selection of working units:
• Press the PLUS or MINUS keys to select
the appropriate units.
• Press the PROGRAM key to accept the
value and advance to the next program step.
Figure 4-1: Selection of Working Units
vnit
US
Reset.to.Defaults
NOTE: If no changes were made to the units, this
step is skipped and setup will automatically
advance to the Speed Sensor Calibration
Step.
If changes have been made to the units during the
first programing step, the console will inquire if all
the program parameters should be reset to the
defaults specified for the units chosen.
• Press the PLUS or MINUS keys to select
either “Yes” or “No”.
• Press the PROGRAM key to accept the
value and advance to the next program step.
Figure 4-2: Reset Defaults
dFLt
YES
uS
res
CHAPTER 3 - SYSTEM SETUP MODE
The System Setup Mode contains the programming steps that customize the controller to the sprayer
components. These include the calibration steps and parameters that seldom change once programmed.
To enter into System Setup Mode, power on the unit. Press and hold the PROGRAM key for 3 seconds
while in operating mode.