TeeJet 854 Sprayer Control - Manual (Page 13)

www.teejet.com
8
854 Sprayer Control
Dual.Boom.Regulation.Mode
NOTE: This step will only be displayed if “Dual
Boom” was selected during the DIGITAL
OUTPUT #2 step.
Dual Boom Regulation Mode is used to regulate
the dual boom feature by either speed (SPD) or
pressure (PRS).
If speed is used to regulate the mode, when the
vehicle reaches the designated speed, the second
boom line will turn On/Off.
If pressure is used to regulate the mode, when
the pressure reaches the designated amount, the
second boom line will turn On/Off.
• Use the PLUS or MINUS keys to change
the value.
• Press the PROGRAM key to accept the
value and advance to the next program step.
The value selected will determine how programming
steps appear during System Setup Mode. Specific
speed or pressure values to be used during
operation are selected during the System Setup
Mode.
Figure 3-12: Dual Boom Regulation Mode - Speed
db
db
SPd
PrS
re6
re6
Figure 3-13: Dual Boom Regulation Mode - Pressure
db
db
SPd
PrS
re6
re6
Fill.Valve.Default
NOTE: This step will only be displayed if “Dual
Boom” was selected during the DIGITAL
OUTPUT #2 step.
The Fill Valve Default establishes the normal
operating state of the fill valve being used. If the fill
valve requires a +12v signal during the spraying
operation, the valve default is “On”. If the fill valve
requires a +12v signal during the filling operation,
the valve default is “Off”.
• Use the PLUS or MINUS keys to change
the value.
• Press the PROGRAM key to accept the
value and advance to the next program step.
Figure 3-14: Fill Valve Default
FiL OUt
OFF dFLt