SilentKnight SK-5208 Conventional FACP 10-30 Zone - Manual (Page 31)

Model SK-5208 Installation Manual 151204
3-21
C1 is the coil for the relay 1, C2 is the coil for relay 2, C3 and C4 are the coils for relays 3 and 4 respectively.
Figure 3-17 Relay Wiring on the SK-5280
Note: Figure 3-17 uses A7 and T7 to activate relays 3 and 4 as an example. However, any of the outputs can be
used to trip any of the relays.
3.14.3.3 Wiring LEDs to Outputs
The outputs (A1-A10 and T1-T10) can be used to operate LEDs used in a remote annunciator (see Figure 3-18).
Outputs A1-A10 are alarm outputs for the zones corresponding to those outputs. For example, if the SK-5280 is
programmed to output for zones 11-20, then outputs A1-A10 will correspond with zones 11 through 20.
Outputs T1-T10 are trouble outputs for the zones corresponding to those outputs. for example, if the SK-5280 is
programmed to output for zones 21-30, then outputs T1-T10 will correspond with zones 21-30.
Figure 3-18 LED Wiring on the SK-5280
Relay Rating
2.5A @ 30 VDC/120 VAC