Keri Systems TAP100 User Manual

Page 42

TAP 100 Application Software Manual

Page 42

Revision 3.3

If all of the assignment information is correct, use your pointing device and select OK. The
TAP100 software will return to the I/O Assignments prompt box and display the following
information.

Once the I/O assignments have been made, you can PRINT a hard copy of the information just
entered. This will allow you to review the I/O assignment information one last time before sending
this information to the control units. To print a hard copy of the I/O assignments, use your pointing
device and select PRINT. The following prompt box will appear.

As the I/O assignment information is being printed, the status bar in this prompt box will monitor
how far along the print process is. When the print job has finished, you can review the I/O
assignment information and verify it is correct. The printout will appear something like this.

I/O ASSIGNMENTS

INPUT

INPUTS

OUTPUT

OUTPUTS

LINK

READER

1 2

Reader 2 (01)

Reader 2 (02)

-----Available -----

• • •

Reader 1 (01)

Reader 2 (02)

MODIFY

SEND

CLEAR

QUIT

I/O ASSIGNMENTS FOR LINK 1

Input Reader:

Sup I/O: No

Polarity: Norm. Closed

Input Lines:

1
2
3
4

Output Reader:
Output Lines:

1
2

2 Reader 2

( ) Active ( • ) Normal ( ) Tamper ( ) None
( ) Active ( ) Normal ( ) Tamper ( ) None
( ) Active ( ) Normal ( ) Tamper ( ) None
( ) Active ( ) Normal ( ) Tamper ( ) None

[ X ] Send to PC

2 Reader 2

( ) Not Used ( ) Deactivate ( ) Activate ( ) Momentary
( ) Not Used ( ) Deactivate ( ) Activate ( ) Momentary