Keri Systems TAP100 - Manual (Page 23)

TAP100 Application Software Manual
Revision 3.3 Page 23
The status message line will display:
To exit this command without making a change, press . To restore the IRQ and ADDR
values to the factory default, press . To change an IRQ/ADDR value, use your pointing
device, move the blinking cursor to the IRQ or ADDR fields, and type in the IRQ and ADDR
values for your PC system.
For example: To change COM4 to IRQ 7, ADDR 0FF8, place the cursor in the COM4, IRQ field
and type:
7
Then place the cursor in the COM4, ADDR field and type:
0FF8
Verifying Network Operation
If the TAP100 software has been configured for COM port/serial communication, this command is
used to verify the access control system network is communication properly. To verify network
communication, use your pointing device and select Utility and then Query Network. The status
message line will state:
Once communication has been established, the status message line will go blank and the
following prompt box will appear.
Advanced COM Setup
PORT IRQ ADDR
COM1 4 03F8
COM2 3 02F8
COM3 4 03E8
COM4 3 02E8
ENTER = accept ESC = quit
F1 = restore default values
Initiating communication with local network on COM1 . . . please wait.
Network Information
System ID = 0
Net Faults = 0
P/O Self Test Fail = 0
P/O Count = 0
Net Security = Secured
Status of Doors = 00000000
Responding Nodes = 00000001
Favorite Nodes = 00000001
Links in Bindery = 0
Customize IRQ assignments and interrupt service vectors.
OK