Keri Systems TAP100 - Manual (Page 22)

TAP 100 Application Software Manual
Page 22 Revision 3.3
To set the phone dialing method, use your pointing device and select Dialing Method. A prompt
box will appear, displaying the two options.
The status message line will display:
Use your pointing device and select the dialing method that meets your telephone system and
select OK. Or, select QUIT to exit the selection without making a change.
Phone Hangup
To ensure proper disconnect of the telephone line following modem operations, use the phone
hangup command. Use your pointing device and select Utilities, and then Phone Hangup. The
following prompt box will appear.
If you are not ready to hang-up the phone, use your pointing device and select NO/CANCEL to
exit the selection without disconnecting the modem. Otherwise, use your pointing device and
select YES/OK. The modem will be disconnected from the telephone line.
Advanced Communication Setup Parameters
The advanced com command asks you to define the interrupt request values and port addresses
for the four communication ports (COM1 through COM4). This command should be used
carefully. You must know the correct values to enter in these fields; an incorrect entry can entirely
disable your PC’s communication ability.
To define the interrupt request values and port addresses for the four communication ports, use
your pointing device, and select Advanced COM. A prompt box will appear with a table displaying
the factory default com port interrupt request values and port addresses.
Dialing Method
( • ) Tone
( ) Pulse
OK QUIT
Select tone or pulse dialing.
You are about to hang up the phone.
DO YOU REALLY
WANT TO DO THIS?
YES/OK NO/CANCEL