Projector user commands, Description, Example – Canon SX 50 User Manual
Page 92: Commands supported, Environment
Projector User Commands
- 86 -
Revision History / Date
Changes
Revised by
Approved by
Description
This emulates pressing of the remote control buttons for controlling the projector.
(1) It can only be used during Local mode.
Note 1
With the emulation of the remote control operations, the functions of the buttons corresponding to the parameters cannot
necessarily be executed. Emulation simply consists in emulating the pressing of the buttons.
Note 2
The following functions are unavailable in remote control emulation.
- USB mouse function
- Function for transfer to special mode (service mode)
Note 3
A parameter with '+REP' signifies "button press start." (This is the same as the status in which the remote control button is
held down.)
Be absolutely sure to send the '*-REP' parameter, and end the button pressing last of all.
The button pressing is ended in the cases below as well.
1) When a panel or remote control button has been operated
2) When an 'RC' or 'MAIN' command has been received
3) When operation has transferred to the remote mode
Example
Setting
> RC POWER
< i:OK
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 O
O
O O O
O
O O
O
- - O x O
SX6, SX60,
X600
O
O O
O
O
O
O
O
O
O
O
O
x
O
SX7, X700 O
O
O
O
O
O
O
O
O
O
O
O
x
O
SX7 Mark II
O
O
O
O
O
O
O
O
O
O
O
O
x
O
* If a state is not supported, "INVALID_MODE" is returned with the Err response.