Get terminal, Projector user commands, Format – Canon SX 50 User Manual
Page 173: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 167 -
Revision History / Date
Changes
Revised by
Approved by
GET TERMINAL
Terminal setting inquiry
Format
GET□TERMINAL
?△TERMINAL
Response
g:TERMINAL=
IN
This sets to input
OUT
This sets to output
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the current terminal setting.
(1) Inquiry can be made when the projector is in both the remote mode and power-on status at the same time.
(2) The terminal can be set by the TERMINAL command
Example
> GET TERMINAL or ? TERMINAL
< g:TERMINAL=OUT
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O x x x x x x
* When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
Parameter
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
IN
O
O
O
O
O
O
-
-
O
O
x
SX50
OUT
x O
x
O
O
x x O
O
- - O O
x
SX6, SX60,
X600
- -
-
-
- - - - - - - - - - -
SX7,
X700 - -
-
-
- - - - - - - - - - -
SX7
Mark
II - -
-
-
- - - - - - - - - - -
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “TERMINAL_OUT” is returned with the Err
response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference