Details of command, Alphabetic command name, Projector user commands – Canon SX 50 User Manual
Page 23: Format, Parameter, Response, Description, Example, Commands supported, Environment
Projector User Commands
- 17 -
Revision History / Date
Changes
Revised by
Approved by
9. Details of Command
Descriptions of each command are provided starting from the next page.
The command descriptions have the format shown below.
Alphabetic command name
This briefly describes the command function.
Format
This indicates the command format.
Parameter
< Parameter name : Parameter types>
This explains the required parameters for the command.
Response
This describes the command response.
Description
This includes the command function, conditions, and notes.
Example
This provides command usage examples.
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
* Indicated here are the commands supported by each model (and user command version). "O": supported; "x": not
supported.
Environment
This defines the environments that support the command (power supply state, input signal state,
control mode).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1
A-RGB2
COMP
Video S-Video D-Video SCART None Remote Local
Remarks
*
1
*
2
*
3
*
4
*
4
*
4
*
4
*
4
*
4
*
4
*
4
*
5
*
6
*
6
*1 OFF
“O” when power supply state is OFF.
*2 ON
“O” when power supply state is ON.
*3 PM
“O” when the power supply state is enabled while power management is in standby.
*4 Input
The command is enabled in states marked by “O”.
*5 None Input signal is required when “X“.
*6 Mode The command is enabled in control modes marked by “O”.
Command type