Get signalstatus, Projector user commands, Format – Canon SX 50 User Manual
Page 171: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 165 -
Revision History / Date
Changes
Revised by
Approved by
GET SIGNALSTATUS
Signal status inquiry
Format
GET□SIGNALSTATUS
?△SIGNALSTATUS
Response
g:SIGNALSTATUS=
NO_SIGNAL Signal
not
detected
DISPLAYING
Image now displayed or display enable status
SETTING
Signal detection and display preparation in progress
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the current image signal input status.
(1) For SX50: Inquiry can be made when the projector is in both the remote mode and power-on status at the
same time.
For models other than SX50: Inquiry can be made whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
For the "SX50," the remote mode must be established.
(3) This returns the signal status of the selected input. Use INPUT command for the input selection.
(4) Even if the status is "DISPLAYING" (image now shown), the image is not displayed during blanking.
Check the status using GET BLANK. To clear the blank status, use BLANK=OFF.
(5) Similarly, the image is not displayed during "no show".
Check the status using GET NOSHOWSTATUS.
To clear no show, execute RC NOSHOW.
Example
> GET SIGNALSTATUS or ? SIGNALSTATUS
< g:SIGNALSTATUS=NO_SIGNAL
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x
O
x O O
O
O O
O
- - O O x
SX6, SX60,
X600
x
O
x
O
O
O
O
O
O
O
O
O
O
O
SX7, X700
x
O
x
O
O
O
O
O
O
O
O
O
O
O
SX7 Mark II x
O
x
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference