Canon SX 50 - Manual (Page 122)

Projector User Commands
- 116 -
Revision History / Date Changes Revised by Approved by
GET ACADJUST
Advanced color adjustment inquiry
Format
GET□ACADJUST
?△ACADJUST
Response
g:ACADJUST=
NOCORRECT No adjustment
MEM_L Low memory color adjustment
MEM_M Medium memory color adjustment
MEM_H High memory color adjustment
6AX 6-axis adjustment
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the details of the current advanced color adjustment.
(1) Inquiry can be made when the projector is in both the remote mode and power-on status at the same time.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) The advanced color adjustment can be set by the ACADJUST command.
Example
> GET ACADJUST or ? ACADJUST
< g:ACADJUST=6AX
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O x x x x x x
* When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power Input Mode
Model
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x O x x x x O O O - - O O x
SX6, SX60,
X600
- - - - - - - - - - - - - -
SX7, X700 - - - - - - - - - - - - - -
SX7 Mark II - - - - - - - - - - - - - -
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference