Range ledilluminate, Projector user commands, Format – Canon SX 50 User Manual
Page 208: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 202 -
Revision History / Date
Changes
Revised by
Approved by
RANGE LEDILLUMINATE
Emotional LED and signal sensing LED lighting setting option request
Format
RANGE□LEDILLUMINATE
Response
r:LEDILLUMINATE=I,
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the parameter options which enable emotional LED and signal sensing
LED lighting control to be set.
(1) For models other than SX7 Mark II: Inquiry can be made when the projector is in both the remote mode
and power-on status at the same time.
For SX7 Mark II: Inquiry can be made whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) LED lighting control can be set using the LEDILLUMINATE command.
Example
> RANGE LEDILLUMINATE
< r:LEDILLUMINATE=I, ON, OFF
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
x O O O O O O
* When a command is not supported, "e:000A INVALID_PARAMETER" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 -
-
- - - - - - - - - - - -
SX6, SX60,
X600
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7, X700
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7 Mark II x
O
x
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference