Get romver, Projector user commands, Format – Canon SX 50 User Manual
Page 166: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 160 -
Revision History / Date
Changes
Revised by
Approved by
GET ROMVER
ROM version inquiry
Format
GET□ROMVER
?△ROMVER
Response
g:ROMVER="
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the product name of the projector.
(1) This inquiry can be made in any status provided that AC power is supplied to the projector.
For the "SX50," the projector must be in the remote mode and power-on status.
Example
> GET ROMVER or ? ROMVER
< g:ROMVER="01.0306"
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x
O
x O O
O
O O
O
- - O O x
SX6, SX60,
X600
O
O O
O
O
O
O
O
O
O
O
O
O
O
SX7, X700 O
O
O
O
O
O
O
O
O
O
O
O
O
O
SX7 Mark II O
O O
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference