Canon SX 50 - Manual (Page 100)

Projector User Commands
- 94 -
Revision History / Date Changes Revised by Approved by
SAT
Color saturation setting
Format
SAT=
Parameter
Saturation setting -20 to 20
The parameters which can be set at any given point in time can be obtained using the
RANGE command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This sets the screen color saturation.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) It may not be possible to execute the command with some input signals.
(4) This command is the same as the menu functions in the table below.
Model Menu
SX50 [Image adjustments] - [Saturation]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[Image adjustments] - [Color adjustments] - [Saturation]
(5) This sets the currently selected input signal and image mode.
(6) The GET command can be used to retrieve the current color saturation.
For details, refer to the GET command.
Example
Setting
> SAT=-10 This sets the color saturation to –10.
< i:OK
Reference
> GET SAT or ?SAT This retrieves the color saturation.
< g:SAT=1
Obtain settable parameter range (Min, Max)
> RANGE SAT
< r:SAT=N,-20,20 Any value from -20 to 20 can be set for the saturation.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Setting