Get logopos, Projector user commands, Format – Canon SX 50 User Manual
Page 151: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 145 -
Revision History / Date
Changes
Revised by
Approved by
GET LOGOPOS
User image position inquiry
Format
GET□LOGOPOS
?△LOGOPOS
Response
g:LOGOPOS=
UPPER_L Upper
left
UPPER_R Upper
right
CENTER Center
LOWER_L Lower
left
LOWER_R Lower
right
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the current user screen (logo) display position.
(1) Inquiry can be made when the projector is in both the remote mode and power-on status at the same time.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) An inquiry cannot be made if the user image has not been registered.
(The error "e:1002 NO_LOGO_CAPTURED" is returned.）
(4) The user image position can be set by the LOGOPOS command.
Example
> GET LOGOPOS or ? LOGOPOS
< g:LOGOPOS=LOWER_L
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O x
* When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x
O
x O O
O
O O
O
- - O O x
SX6, SX60,
X600
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7, X700
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7 Mark II -
-
- - - - - - - - - - - -
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference