6axadj, Projector user commands, Format – Canon SX 50 User Manual
Page 24: Parameter, Response, Description, Example, Commands supported, Environment
Projector User Commands
- 18 -
Revision History / Date
Changes
Revised by
Approved by
6AXADJ
6-axis adjustment ON/OFF
Format
6AXADJ=<6-axis adjustment parameter:ID>
Parameter
<6-axis adjustment parameter:ID>
ON
This sets the 6-axis adjustment to ON.
OFF
This sets the 6-axis adjustment to OFF.
The parameters which can be set at any given point in time can be obtained using the RANGE command. For
details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This command is used to select ON or OFF for the 6-axis adjustment.
(1) For models other than SX7 Mark II:
It can be executed when the projector is in both the remote mode and power-on status at the same time.
For SX7 Mark II:
It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) In the case of "6-axis adjustment," set the hue and color saturation of each axis using the 6AXR to Y
"6-axis correction R to Y hue/color saturation setting" commands.
(4) This command functions in the same way as when "Image adjustments" - "Advanced adjustments" -
"6-axis adjustment" are selected on the menu.
(5) This sets the currently selected input signal and image mode.
(6) The GET command can be used to retrieve the current 6-axis adjustment setting.
For details, refer to the GET command.
Example
Control
> 6AXADJ=ON
The 6-axis adjustment is set to ON.
< i:OK
Reference
> GET 6AXADJ or ?6AXADJ The 6-axis adjustment ON or OFF setting is obtained.
< g:6AXADJ=ON
Acquisition of parameters which can be set
> RANGE 6AXADJ
< r:6AXADJ=I, ON, OFF
The 6-axis adjustment can be set as “ON” or “OFF”.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
x O O O O O O
* When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 -
-
- - - - - - - - - - - -
SX6, SX60,
X600
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7, X700
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7 Mark II
x
O
x
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Setting