Canon SX 50 - Manual (Page 31)

Projector User Commands
- 25 -
Revision History / Date Changes Revised by Approved by
AUTOPC
Auto PC
Format
AUTOPC
Response
"i:OK" is returned if the control was executed properly.
For details on other responses, refer to the "Error List".
Description
This executes Auto PC.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) It may not be possible to execute the command with some input signals.
(4) This command is identical to pressing the “AUTOPC” button on the remote control.
(5) Execution of this command may modify the following setting values.
・ Total number of dots ・ Tracking
・ Horizontal/vertical positions ・ Number of horizontal/vertical display dots
(6) To confirm modified setting values, use the GET command of the respective parameter.
(7) For details, refer to the GET commands below.
Setting GET
Total number of dots GET DOTS
Tracking GET TRACK
Horizontal position GET HPOS
Vertical position GET VPOS
Number of horizontal display dots GET HPIX
Number of vertical display dots GET VPIX
Example
> AUTOPC
< i:OK
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power Input Mode
Model
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x O x x O O x x x - - x O x
SX6, SX60,
X600
x O x x O O x x x x x x O x
SX7, X700 x O x x O O x x x x x x O x
SX7 Mark II x O x x O O x x x x x x O O
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “INVALID_SOURCE” is returned with the Err
response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Control