Canon SX 50 - Manual (Page 106)

Projector User Commands
- 100 -
Revision History / Date Changes Revised by Approved by
TERMINAL
Terminal setting
Format
TERMINAL=
Parameter
IN This sets to input
OUT This sets to output
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This sets the input/output of the RGB-IN2/COMPONENT IN/RGB OUT terminals.
(1) It can be executed when the projector is in both the remote mode and power-on status at the same time.
(2) This command functions in the same way as when " System settings" - " Terminal" are selected on the
menu.
(3) The “OUT” (output) setting cannot be made when the “A-RGB2” or “COMP” input is selected!
(4) The GET command can be used to retrieve the current terminal setting.
For details, refer to the GET command.
Example
Setting
> TERMINAL=IN This sets to input
< i:OK
Reference
> GET TERMINAL or ?TERMINAL This retrieves the terminal setting state.
< g:TERMINAL=OUT
Acquisition of parameters which can be set
> RANGE TERMINAL
< r:TERMINAL=I, IN, OUT "IN" or "OUT" can be selected as the terminal setting.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O x x x x x x
* When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Environment
This defines the environments that support the command (power supply state, input signal state).
Power Input Mode
Model
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x O x x x x O O O - - O O x
SX6, SX60,
X600
- - - - - - - - - - - - - -
SX7, X700 - - - - - - - - - - - - - -
SX7 Mark II - - - - - - - - - - - - - -
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “TERMINAL_OUT” is returned with the Err
response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Setting