Canon SX 50 - Manual (Page 90)

Projector User Commands
- 84 -
Revision History / Date Changes Revised by Approved by
Example
Setting
> PROG=0 This sets the progressive conversion setting to OFF.
< i:OK
Reference
> GET PROG or ?PROG This acquires the progressive conversion processing status.
< g:PROG=1
Acquisition of parameters which can be set
> RANGE PROG
< r:PROG=I, 0, 1, 2 "0", "1" or "2" can be selected as the progressive conversion setting.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power Input Mode
Model
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x O x x x x O O O - - x O x
SX6, SX60,
X600
x O x x x x O O O x x x O x
SX7, X700 x O x x x x O O O x x x O x
SX7 Mark II x O x x x x O O O x x x O O
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “INVALID_SOURCE” is returned with the Err
response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.