Canon SX 50 - Manual (Page 43)

Projector User Commands
- 37 -
Revision History / Date Changes Revised by Approved by
DOTS
Total number of dots adjustment
Format
DOTS=
Parameter
Number of dots
The RANGE command can be used to obtain the parameter range that can be set at that time.
For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This designates the total number of dots for one horizontal period.
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) It may not be possible to execute the command with some input signals.
(4) This command is the same as the menu functions in the table below.
Model Menu
SX50 [Display settings] - [Input signal settings] - [Total number of dots adjustments]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[Display settings] - [Input signal settings] - [Total number of dots]
(5) The GET command can be used to retrieve the current total number of dots.
For details, refer to the GET command.
Example
Setting
> DOTS=1650 The total number of dots is 1650.
< i:OK
Reference
> GET DOTS or ?DOTS This retrieves the total number of dots.
< g:DOTS=1200
Obtain settable parameter range (Min, Max)
> RANGE DOTS
< r:DOTS=N, 0, 4096 Any value from 0 to 4096 can be set for the total dots.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Setting