Canon SX 50 - Manual (Page 44)

Projector User Commands
- 38 -
Revision History / Date Changes Revised by Approved by
Environment
This defines the environments that support the command (power supply state, input signal state).
Power Input Mode
Model
OFF ON PM D-RGB A-RGB1 A-RGB2 COMP Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x O x x O O x x x - - x O x
SX6, SX60,
X600
x O x x O O x x x x x x O x
SX7, X700 x O x x O O x x x x x x O x
SX7 Mark II x O x x O O x x x x x x O O
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “INVALID_SOURCE” is returned with the Err
response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.