Local, Projector user commands, Format – Canon SX 50 User Manual
Page 70: Response, Description, Example, Commands supported
Projector User Commands
- 64 -
Revision History / Date
Changes
Revised by
Approved by
LOCAL
Switch to local mode
Format
LOCAL
Response
"i:OK" is returned when it was possible to switch the mode properly.
For details on other responses, refer to the "Error List".
Description
This switches to Local mode.
(1) The following commands can be used while the local mode is established (for models other than SX7 Mark
II).
Errors supported by model
Cammand/parameter
SX50
01.00**
SX6, SX60, X600, SX7, X700
01.01**
REMOTE O
O
LOCAL O
O
GET MODE
O
O
GET COMVER
X
O
GET ERROR
X
O
GET FREEZE
X
O
GET INPUT
X
O
GET LAMP COUNTER
X
O
GET MUTE
X
O
GET NOSHOWSTATE
X
O
GET POWER
X
O
GET PRODCODE
X
O
GET ROMVER
X
O
GET SIGNALSTATUS
X
O
MAIN O
O
RC O
O
(2) For SX7 Mark II, all commands can be used.
(3) This command can be used in any projector mode.
(4) However, zoom or focus lens drive stops if the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(5) The current mode can be referenced using the applicable GET command
(6) The "BLANK status" is cleared. Refer to BLANK command.
Example
Mode switching
> LOCAL
< i:OK
Mode viewing
> GET MODE or ?MODE
< g:MODE=LOCAL
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Mode