Get sel – Canon SX 50 User Manual
Page 169
Projector User Commands
- 163 -
Revision History / Date
Changes
Revised by
Approved by
GET SEL
Input signal inquiry
Format
GET□SEL
?△SEL
Response
g:SEL=
PAL
Includes PAL-M and PAL-N
SECAM
NTSC Includes
NTSC4.43
1080i
Includes 540p (1080i non-interlaced signal)
1035i
720p
575p
480p
575i
Includes 288p (PAL non-interlaced signal)
480i
Includes 240p (NTSC non-interlaced signal)
UNKNOWN
No-color, 1080p, and other signals
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the current input signals.
(1) For models other than SX7 Mark II: Inquiry can be made when the projector is in both the remote mode
and power-on status at the same time.
For SX7 Mark II: Inquiry can be made whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) It may not be possible to make this inquiry with some input signals.
(4) The input signals can be selected by the SEL command.
Example
> GET SEL or ? SEL
< g:SEL=575p
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x
O
x x x x O O
O
- - x O x
SX6, SX60,
X600
x
O
x x x x O O
O
x x x O x
SX7,
X700
x
O
x x x x O O
O
x x x O x
SX7 Mark II x
O x x
x
x
O
O
O
x
x
x O O
* If a state is not supported, "INVALID_MODE", "NOT_POWER_SUPPLIED" or “INVALID_SOURCE” is returned with the Err
response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Reference