Canon SX 50 - Manual (Page 32)

Projector User Commands
- 26 -
Revision History / Date Changes Revised by Approved by
AUTOSETEXE
Auto setup
Format
AUTOSETEXE□
Parameter
FOCUS Auto focusing
VKS Auto keystone (vertical) execution
SCRN Automatic screen color correction execution
INPUT Automatic signal sensing execution
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
“ i:OK” is returned when the automatic processing was completed successfully.
One of the following responses is returned if an error has been detected at any part of the auto setup.
Type Error response
FOCUS e:F002 SYSTEM (FOCUS)
VKS e:F004 SYSTEM (AUTO_KEYSTONE)
SCRN e:F005 SYSTEM (SCREEN_COLOR)
For details on other responses, refer to the "Error List".
Description
This command is used to execute auto setup.
(1) For models other than SX7 Mark II:
It can be executed when the projector is in both the remote mode and power-on status at the same time.
For SX7 Mark II:
It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) There are no parameters to be executed together. Execute them separately.
(4) It is not possible to execute auto setup in some projector statuses.
Type Statuses in which auto setup cannot be executed Remarks
FOCUS Auto setup cannot be executed while "BLANK" is underway. Refer to the BLANK command.
VKS -
SCRN Auto setup cannot be executed while "BLANK" is underway. Refer to the BLANK command.
INPUT Auto setup cannot be executed if there are no input signals.
(5) When automatic screen color correction (SCRN) has been completed successfully, the screen color
correction (WB) is set to "ADJUST."
(6) “FOCUS”, “VKS” or “SCRN” cannot be executed when the screen aspect is “16:9_DIS”.
"e:1008 INVALID_SCREEN_ASPECT" is returned.
Example
Setting
> AUTOSETEXE FOCUS Auto focusing is executed.
< i:OK
Acquisition of parameters which can be set
> RANGE AUTOSETEXE
< r:AUTOSETEXE=I, FOCUS, VKS, SCRN, INPUT
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
x O O O O O O
* When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Control