KEYENCE DL-CL1 - Manual (Page 33)

3-2 Device Maps
3-5
3
Comm
u
nic
a
ti
ng
w
it
h th
e
SK-1
000 Se
ri
es
- CC-Link Compatible Network Unit DL-CL1 User’s Manual (SK-1000) -
Number [n] denotes the first relay number assigned to the DL-CL1.
*1 Refer to "Reading an Output from a Sensor Amplifier" (page 3-18).
*2 Refer to "Monitor mode 1" (page 3-19).
*3 Refer to "Changing the BANK Number of Sensor Amplifiers" (page 3-21).
*4 Refer to "Reading/Writing Settings or Status of a Sensor Amplifier" (page 3-23).
*5 Refer to "Issuing a Motion Command to a Sensor Amplifier" (page 3-22).
Mo
ni
to
r mo
de
1
RX[n] + 52 Command error *4
Used when communicating under
handshake control program.
This is output when an error occurs
during command execution.
0: No error
1: Error
RX[n] + 53
Judgment value
update lock
state
-
This is output when judgment
value (P.V. value) update is locked
(judgment value update lock
request (RY[n] + 53) is ON).
0: Update enabled
1: Update locked
RX[n] + 54
to 5D
System reserved - Unusable -
RX[n] + 5E
Judgment value
page change
complete
*2
Used when reading judgment
value (P.V. value).
This is output when judgment
value page has been changed.
0->1: Change
complete
RX[n] + 5F
Judgment value
page change
error
*2
Used when reading judgment
value (P.V. value).
This is output if an error occurs
while changing the judgment value
page.
0: No error
1: Error
RX[n] + 60
to 67
BANK change
complete ID 01
to ID 08
*3
Used when changing BANK
number.
This is output when BANK number
has been changed.
The output of each sensor amplifier (ID
01 to ID 08) corresponds to each RX.
0->1: Change
complete
RX[n] + 6F
BANK change
error
*3
Used when changing BANK
number.
This is output if an error occurs
with a sensor amplifier of any ID
number during BANK number
changing.
0: No error
1: Error
RX[n] + 1B
Remote ready -
This is output when the DL-CL1 is
correctly connected to the CC-Link
system.
1: Proper communication is
provided. Data from the sensor
amplifier will be updated.
0: Proper communication is not
provided. Data from the sensor
amplifier will not be updated.
0: In preparation
1: Ready
RX[n] + 3B
RX[n] + 7B
Operating
mode
Device no.
(HEX)
Name
Communication
method
Description Reading range