Powering the f6 modular i/o frame, F6 m, I/o f – Aviom AllFrame User Manual
Page 34: Owering, Odular, Rame, All frame
22
P
owering
The
a
ll
f
rame
ALL
FRAME
™
Multi-Modular I/O System
P
oWeriNg
the
F6 m
odulAr
i/o F
rAme
The F6 Modular I/O Frame is a DC-powered device that can be powered in a variety of ways:
Via the
•
4-pin XLR connector on the F6 top panel
Via the 2-pin
•
Euroblock connector on the F6 top panel
Over the
•
A-Net cable using an approved Power Over A-Net (PoA) power supply such as the
Aviom POA80 connected to A-Net Port B
All three DC power sources can be connected at the same time to provide power source redundancy without
harming the F6 Modular I/O Frame.
P
N
ote
:
The F6 Modular I/O Frame does not ship with a power supply. It is the installer’s responsibility to
provide a power source best suited for the application where the AllFrame products will be used.
DC Power 65w max
DC POWER
65W MAX
DC Power to the F6 Modular I/O Frame can be supplied through the 4-pin XLR (1), the Euroblock terminals #1-2 (2), and/or over
the A-Net cable using the A-Net B port (3).